Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Temecula, CA
Chimney repair in Temecula usually means one of two things: a cracked flue liner in an older masonry fireplace in the 92590 hills, or a failed factory-built metal flue in a 1990s-2010s tract home in neighborhoods like Redhawk or Paloma del Sol. The work is different in each case, and most of what we find comes from the same source: Temecula’s high-desert temperature swings and Santa Ana winds putting stress on builder-grade installations. San Bernardino Chimney Sweep has served Temecula since 2018, handling repair work alongside sweeping and dryer vent cleaning. If you’re seeing rust stains, mortar chips in the firebox, or smoke backing into the room, call (877) 516-7159 and we’ll tell you what’s actually going on.
Why Temecula Homes Are Different
Most Temecula homes were built between the late 1980s and the 2010s, and the vast majority went in as part of master-planned tracts: Roripaugh Ranch, Paloma del Sol, Redhawk, and similar subdivisions. Those houses got prefabricated metal fireboxes with Direct-Vent or B-Vent flues, installed to builder spec rather than chimney sweep spec. That means flue caps rated for mild conditions, not the Santa Ana winds that rip down through the valley each fall. We routinely pull bird nests out of Temecula flues, and not just soot, because production builders didn’t account for the wind loads this valley actually sees.
The climate adds another layer. Summer days run past 100°F while winter nights in the hills can drop below freezing. That diurnal swing produces some of the most acidic creosote conditions we encounter anywhere in the region. Homeowners in Temecula often burn short, low fires on cool spring and fall evenings, which means creosote accumulates slowly and chimneys go years without inspection. In older custom homes in the 92590 and 92592 hills, we see traditional masonry fireplaces where crown cracks and flashing failures are common thanks to the same heat-and-freeze cycle. Knowing which housing stock you’re dealing with changes the repair approach entirely.
Styles & brands we work with
Our Main Temecula Services
Two services keep Temecula homeowners up at night: chimney sweeping before burn season, and dryer vent cleaning once they learn how much lint is sitting behind the wall. Both are handled by our team, and both are covered on their own Temecula pages.
Chimney Sweep in Temecula
A chimney sweep in Temecula is less about soot and more about what’s hiding inside the flue. Given the wind and the housing stock, we’re looking for dislodged flue caps, bird nests, and creosote that’s gone acidic from the temperature swings. In prefab metal flues, we check the manufacturer’s installation points, because production builders don’t always follow them. This is not a 20-minute inspection. Full details and local pricing are on the dedicated Chimney Sweep in Temecula page.
Dryer Vent Cleaning in Temecula
Dryer vent cleaning protects homes where the Santa Anas push fine dust into every gap, and Temecula’s long dry season means dryer lint sits in the vent for months without any moisture to help it break down. In two-story tract homes from the 1990s and 2000s, we often find vents running 15 to 25 feet with hard right angles that trap lint by design. The vent in your laundry room is a fire risk that has nothing to do with the fireplace. See Dryer Vent Cleaning in Temecula for costs and process.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Temecula
Chimney repair in Temecula is where we spend most of our time, because the local conditions create specific, recurring failures: wind-damaged flue caps on production-built metal flues, and crown and flashing failures on the masonry fireplaces in the older hill neighborhoods. The good news is most of these are repairable without a full rebuild. As a company that handles both sweeping and Chimney Repair, we find the problem during a routine visit and fix it before it becomes a water leak or a fire hazard.
In Temecula specifically, we see more Santa Ana-related cap damage than almost anywhere else in our service area. A cap that’s been blown loose lets rain into the flue, which then rusts the metal liner or deteriorates the mortar joints. We also see cracked crowns from the freeze-thaw cycle in the 92590 hills, where older custom homes with masonry chimneys have been through decades of winter nights below freezing and summer days above 100°F.
Chimney Cap Installation
Signs you need it
Water in the firebox after a rainstorm, or bird activity near the top of the chimney, usually means the cap is missing or the wrong size.
What it costs in Temecula
Chimney cap installation in Temecula typically runs $180 to $470 depending on the cap material and whether a custom size is needed for a builder-grade metal flue.
How we do it
We measure the flue opening, select a cap rated for the wind loads we see in the valley, and anchor it mechanically rather than relying on a friction fit.
Chimney Liner Installation
Signs you need it
Flue tiles cracked, a rusted metal liner, or smoke seeping through the walls of an older masonry chimney means the liner has failed.
What it costs in Temecula
Chimney liner installation in Temecula typically ranges from $2,200 to $5,800 depending on flue length, liner material, and access.
How we do it
We run a DuraFlex flexible liner down the existing flue, connect it properly at the appliance, and seal everything top and bottom.
Chimney Flashing Repair
Signs you need it
Water stains on the ceiling near the fireplace, or damp drywall around the chimney chase, points to failed flashing at the roofline.
What it costs in Temecula
Chimney flashing repair in Temecula typically costs $450 to $1,450, with the range driven by whether we’re replacing a section or redoing the full roofline seal.
How we do it
We remove the old flashing, inspect the underlayment, and install new flashing that moves water down and away instead of letting it pool against the chimney.
Chimney Crown Repair
Signs you need it
Cracks in the concrete or mortar crown on top of a masonry chimney, or chunks of it found in the yard, means water is entering the chimney structure.
What it costs in Temecula
Chimney crown repair in Temecula ranges from $500 to $1,900, depending on whether we’re sealing small cracks or rebuilding the entire crown.
How we do it
We repair or rebuild the crown with a proper overhang and a flexible sealant so the next freeze-thaw cycle doesn’t split it open again.
What Chimney Repair Costs in Temecula
| Item | Typical range in Temecula |
|---|---|
| Chimney cap installation | $180 – $470 |
| Chimney crown repair | $500 – $1,900 |
| Chimney liner installation | $2,200 – $5,800 |
How do I know if I need a new liner or just a repair?
A camera inspection answers that question in ten minutes. In Temecula’s tract homes with metal flues, a failed liner is usually localized and repairable with a patch or resleeving. Only when the liner has corroded through in multiple spots does replacement become the better call. We’ll show you the footage before recommending anything.
How much does chimney repair cost in Temecula?
Most Temecula repairs land between $180 and $1,900. Cap installations sit at the low end, while full liner replacement in a masonry chimney runs $2,200 to $5,800. The final number depends on what the camera finds. Call (877) 516-7159 for a flat quote before any work begins.
Brands We Service in Temecula
We stock and install parts from Famco, Copperfield, and DuraFlex, and we apply HeatShield for chimney resurfacing work. Having the right components on hand means a repaired chimney in Temecula gets fixed with contractor-grade materials, not hardware-store substitutes. See our brands for the full lineup and what we use each one for.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Temecula, CA
| Service | Typical range in Temecula |
|---|---|
| Chimney sweep | $149 – $249 |
| Chimney cap installation | $180 – $470 |
| Chimney cap replacement | $220 – $520 |
| Chimney crown repair | $500 – $1,900 |
| Chimney flashing repair | $450 – $1,450 |
| Chimney liner installation | $2,200 – $5,800 |
| Dryer vent cleaning | $99 – $189 |
What pushes a Temecula job toward the upper end? Roof pitch and access on hill homes in 92590 and 92592, damaged flue caps that need replacement rather than reinstallation, and masonry chimneys that have been absorbing water for years before anyone noticed. We quote a flat price before any repair work starts, so there are no surprises after the fact.
Neighborhoods We Serve in Temecula
We work throughout the Temecula valley, from the master-planned tracts near the 15 freeway to the older custom homes in the hills on both sides. Most of our calls cluster in the neighborhoods below, and we typically reach any Temecula address within the same week, often sooner during the spring and fall sweep seasons.
- Redhawk
- Paloma del Sol
- Roripaugh Ranch
- Paseo del Sol
- Meadowview
Service Area – Cities Near Temecula
Beyond Temecula proper, our trucks cover the surrounding valley communities and the hills to the east. Homeowners in Murrieta Hot Springs, CA, Murrieta, CA, Rainbow, CA, and Wildomar, CA call us for the same specialized chimney and ventilation work. If you’re anywhere along the 15 corridor north of San Diego County, we can usually get to you within the same week.
Serving Temecula, CA — Our Local Coverage Area
We’re based in the Temecula area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Temecula
Most Temecula homeowners get a visit within one week of calling. During fall and spring, when Santa Anas knock caps loose and people start burning again, we prioritize the 92590 and 92592 hill areas where damage tends to be more severe. Call (877) 516-7159 and we’ll book you in the next open slot.
Some larger subdivisions, like Redhawk and Paloma del Sol, have HOA guidelines about exterior changes including chimney caps. A standard cap replacement rarely needs approval, but a custom cap in a visible location might. We’ll tell you if the job looks like something your HOA would want to know about before we start.
Yes, and we do it frequently in Temecula. A single visit can include a chimney sweep plus dryer vent cleaning, which saves a trip across the valley. If the chimney inspection turns up a repair issue, we’ll quote it then and schedule a follow-up, often the same week.
Call (877) 516-7159 for a free estimate on any chimney or dryer vent work in Temecula.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Temecula Customers Say
"Level two inspection before we bought the house. The report was detailed enough to use as a negotiating point and he explained every photo in it."
— Ebony Nash"Creosote buildup was worse than I realized. He measured it, showed me the glazing on the flue with the camera, and was honest that we were closer to a chimney fire than I wanted to hear."
— Eric Rhodes"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Robert Quinn