Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in El Monte, CA
Chimney repair in El Monte usually means one of a few things: a rusted-out damper in a 1950s brick fireplace, a cracked crown letting winter rain into the masonry, or missing caps that turned the flue into a pigeon coop over the long San Gabriel Valley summer. We see all three on a regular basis. If you’ve noticed water staining near the firebox, a damper that won’t budge, or a smell like a wet campfire when the Santa Anas blow through, call us at (877) 516-7159 and we’ll come take a look.
Why El Monte Homes Are Different
El Monte’s housing stock tells the story. Most of the city is post-WWII tract housing from the 1940s through 1960s, and those original masonry fireplaces were built to a different standard than what code requires today. Flues run undersized for modern wood-burning expectations, damper assemblies have decades of rust and warp, and a surprising number of the older brick chimneys off Valley Boulevard never got a cap installed. We know exactly what to expect when we climb up on a roof in the 91731 and 91732 ZIP codes.
The climate creates a second layer of problems. El Monte’s hot, dry summers and mostly rainless winters mean fireplaces sit dormant for eight or nine months at a stretch. That’s not idle time. That’s time for creosote left from last winter’s fires to harden into a glazed, tar-like coating that burns hotter and clings harder than the fluffy stuff you get in colder climates where fireplaces run all season. When the first December cold snap hits and you light that first fire, it’s not just a fresh start. It’s often a smoke-backed-up-into-the-living-room call to us. The occasional winter rain is another quiet problem. It seeps into uncapped masonry and spalls the brick face, or it rusts the seams on 1980s prefab metal fireboxes in the newer infill lots. El Monte’s own seasonal rhythm dictates what we find up there.
Styles & brands we work with





Our Main El Monte Services
The two services El Monte homeowners call us about most are chimney sweeping and dryer vent cleaning. Here’s what each involves in this city.
Chimney Sweep in El Monte
An annual sweep in El Monte is about clearing glazed creosote, not just loose soot. The long idle season between burns hardens deposits that a brush alone can’t always remove, which is why our sweep includes an inspection of the full flue path and damper operation. In the older tracts, we’re also checking for nesting material from birds and squirrels that moved in during the off-season. Homeowners who haven’t had the chimney opened in a few years are often surprised by what’s blocking the path. If you’re due for a cleaning, see our dedicated page on Chimney Sweep in El Monte for the full walkthrough, including what to expect on the day of the visit.

Dryer Vent Cleaning in El Monte
Dryer vent cleaning gets overlooked because the risk is invisible until it isn’t. Lint accumulates in the vent run, restricts airflow, and turns your dryer into a slow-burning fire hazard behind the wall. El Monte’s older tract homes often have long, winding vent runs through the attic or under the slab, which collect more lint than a short direct run. If your clothes are taking two cycles to dry or the laundry room smells like a laundromat after every load, that’s a sign. Read more on the El Monte page for Dryer Vent Cleaning in El Monte about how we clean runs, not just the trap.

What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in El Monte
Chimney repair in El Monte is often a masonry and damper problem first. The 1940s and 1950s brick fireplaces that dominate the city’s housing stock were built with undersized flues and simple cast-iron dampers that corrode under decades of Southern California’s diurnal temperature swings. Add a few winter rains and a chimney cap that was never installed, and you’ve got spalled brick faces, rusted damper assemblies, and water making its way to the firebox. That’s the work we do under Chimney Repair: identify the actual failure, show you the camera evidence, and fix it with materials that hold up. For older El Monte homes, repair rather than replacement is usually the right call, because replacing a brick chimney that’s structurally sound just because the crown is cracked or the damper is seized is an expense nobody needs to eat.
Chimney Cap Installation
Signs you need it
If you can see daylight through the top of your flue or you’ve heard birds in the wall near the chimney, you probably don’t have a working cap.
What it costs in El Monte
Chimney cap installation in El Monte typically runs $180 to $360 depending on flue size and access.
How we do it
We measure the flue opening, set a stainless or copper cap sized for your specific tile or pipe, and anchor it with mechanical fasteners rather than caulk alone.
Chimney Crown Repair
Signs you need it
Cracks in the concrete slab at the top of the chimney, or bits of crown material showing up on the roof after rain, mean water is getting into the masonry.
What it costs in El Monte
Chimney crown repair in El Monte typically falls between $400 and $750, though a full recast with proper expansion joint can run higher.
How we do it
We remove the failing crown, form a new one with a proper drip edge and expansion gap, and pour a mix that stands up to El Monte’s hot-dry summer and wet-winter cycle.
What Chimney Repair Costs in El Monte
| Item | Typical range in El Monte |
|---|---|
| Chimney cap installation | $180 – $360 |
| Chimney crown repair | $400 – $750 |
| Chimney flashing repair | $250 – $500 |
How long does chimney repair take in El Monte?
Most cap installations and flashing repairs are done in a single visit, usually two to three hours. Crown repairs need a day to cure, so we schedule those with a dry-weather window in mind.
Do I need a permit for chimney repair in El Monte?
For cap, crown, flashing, and damper repairs, no. Structural rebuilds or full firebox reconstruction can trigger local building permits, but the repairs we’re describing here are considered routine maintenance.
Brands We Service in El Monte
We install and work with parts from Famco, Copperfield, and DuraFlex. When an El Monte repair calls for a flexible liner or a replacement cap assembly, we’re pulling from manufacturer stock rather than whatever generic piece the hardware store had on the shelf. That keeps turnaround short and the parts warranty-backed. For more on how we source, see our brands.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in El Monte, CA
| Service | Typical range in El Monte |
|---|---|
| Chimney sweep (standard inspection included) | $149 – $199 |
| Chimney cap installation | $180 – $360 |
| Chimney cap replacement | $220 – $400 |
| Chimney liner installation (flexible stainless, DuraFlex) | $1,800 – $3,200 |
| Chimney flashing repair | $250 – $500 |
| Chimney crown repair | $400 – $750 |
| Dryer vent cleaning | $99 – $189 |
What pushes price up in El Monte is access. Steep roof pitches on some of the 1960s ranch-style homes, chimneys on the second-story side of a split-level, and flue sizes that no longer match off-the-shelf cap dimensions all affect the final number. We give an upfront price before any work starts, and we don’t add surprise line items when we’re already on the roof.
Neighborhoods We Serve in El Monte
We work across the whole city, from the older tracts off Valley Boulevard to the 1980s infill around Mountain View. Our techs are in El Monte at least once a week, so scheduling usually means within a few days, not a few weeks.
- Valley Boulevard corridor
- Mountain View
- North El Monte border area
- Arden Village
- Five Points
Service Area – Cities Near El Monte
We serve El Monte and the surrounding San Gabriel Valley cities. If you’re a few minutes south, we cover South El Monte, CA with the same inspection and repair scope. We’re also in North El Monte, CA for the homes that straddle the county line, and we work regularly in Temple City, CA and Rosemead, CA. Same crew, same materials, same upfront pricing.
Serving El Monte, CA — Our Local Coverage Area
We’re based in the El Monte area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in El Monte
Yes. We cover 91731, 91732, 91734, and 91735. Our scheduling runs by day of week rather than by ZIP, so the neighborhood you’re in doesn’t change when we can get there.
Book it before the first cold snap, ideally by late October or early November. That way if we find a missing cap, glazed creosote, or a rusted damper, the repair is done before you ever light that first December fire.
We fix what we find. If the sweep turns up a cracked crown, a failing cap, or a damper that won’t seat, the repair happens under the same visit or a scheduled follow-up. No second company, no juggling of estimates.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What El Monte Customers Say
"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Veronica Morales"Drop cloths everywhere, HEPA vac, and not a speck of soot on the carpet. I'd been dreading the mess for nothing."
— Danielle Vaughn"Crown was cracked and taking water. Repaired it rather than quoting a rebuild, which the previous company had pushed hard for."
— Jason Brooks