Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Chimney Company in Irwindale, CA
Chimney repair in Irwindale usually starts with creosote that has bonded to quarry dust and won’t brush off. Most homes here were built in the 1950s and 1960s with original clay tile flues and masonry fireplaces, so age and the local air combine in ways we don’t see in neighboring cities. San Bernardino Chimney Sweep handles both the cleaning and the repair, which means what we find on the roof, we can usually fix the same visit. If your chimney has not been inspected in the last two years, call (877) 516-7159 to schedule.
Why Irwindale Homes Are Different
Irwindale sits on top of some of the largest aggregate mining operations in Southern California. The rock quarries release fine silica and mineral dust into the air, and that dust settles on roofs, screens, and chimney caps. When a fireplace is used, the dust mixes with creosote inside the flue and creates a glaze that is harder and more abrasive than typical creosote. Standard brushing alone often will not cut it. Our technicians in Irwindale hand-scrape glazed creosote and then check the flue tile for cracks the glaze was hiding.
The housing stock tells the same story. Most Irwindale homes are older single-family detached houses from the mid-20th century, with original masonry fireplaces rather than modern inserts. Clay tile flues from that era spall and crack with age, especially after decades of Santa Ana wind cycles and hot, dry summers. The mild winters mean fireplace use is seasonal, but the dry air makes creosote brittle, so it flakes and falls into the smoke shelf more readily. Add the quarry dust that coats spark arrestors after windy days, and you get a chimney that needs a specialist who knows what Irwindale air does to a flue, not a general handyman with a brush.
Styles & brands we work with
Our Main Irwindale Services
The two services Irwindale homeowners call us about most are chimney sweeping and dryer vent cleaning. One addresses fire risk in the fireplace, the other in the laundry room. Both are handled by the same specialized team.
Chimney Sweep in Irwindale
A proper sweep in Irwindale starts with the quarry dust problem. Fine gray dust settles on the cap and screen after every wind event, and once it mixes with creosote, it forms a glaze that standard sweeping tools skip over. We hand-scrape that layer, brush the full flue length, and vacuum the smoke chamber and firebox. Because most chimneys here are original clay tile, we check for spalled mortar and hairline cracks while the flue is clean, so you know whether the system is safe or needs repair before you light the next fire. See our dedicated page for full service details and local pricing: Chimney Sweep in Irwindale.
Dryer Vent Cleaning in Irwindale
Dryer vents clog with lint, and in Irwindale, that lint also carries fine quarry dust that settles on every exterior vent hood. The combination restricts airflow faster than lint alone, which pushes dryer run times up and creates the conditions for a vent fire. We clean the full vent run from the dryer to the exterior termination, remove the accumulated lint and dust, and confirm proper airflow. Your dryer vent is a fire risk too, and it is a core service for us, not an add-on. Full details are on our page: Dryer Vent Cleaning in Irwindale.
What happens when you call
- 1
A real person answersNo phone trees — you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Chimney Repair in Irwindale
Chimney repair in Irwindale typically means addressing what decades of quarry dust, Santa Ana winds, and aging clay tile flues have done to masonry and metal components. Homes here were mostly built in the mid-20th century, and the original chimneys are reaching the age where flashing rusts through, crowns crack, and flue liners spall. When we sweep an Irwindale chimney and find damage, we can usually quote and complete the repair on the spot, because we carry the parts and materials rather than referring you to another company. That is the point of using a specialist: Chimney Repair is our primary job, not a side service. Here are the repairs we perform most often in Irwindale.
Chimney Cap Replacement
Signs you need it
Rain water inside the firebox, visible rust on the cap, or a spark arrestor so caked with quarry dust that it no longer vents smoke.
What it costs in Irwindale
Chimney cap replacement in Irwindale typically runs $190 to $390 depending on cap size and flue diameter.
How we do it
We remove the old cap, measure the flue tile opening, secure a correctly sized replacement cap with a screened spark arrestor, and test the fit.
Chimney Crown Repair
Signs you need it
Hairline cracks across the concrete crown, spalling concrete on the chimney top, or water staining inside the flue after rain.
What it costs in Irwindale
Crown repair in Irwindale costs $455 to $780, which covers cleaning, sealing cracks, and applying a new waterproof crown coat.
How we do it
We clean the existing crown, fill cracks and minor spalls with a polymer-modified patch, and apply a flexible crown sealant that resists the dry-heat expansion Irwindale summers cause.
Chimney Flashing Repair
Signs you need it
Water dripping into the attic around the chimney, stained drywall near the fireplace, or visible gaps where the flashing meets the roofline after Santa Ana winds.
What it costs in Irwindale
Flashing repair in Irwindale is priced from $350 to $690 depending on how much of the existing flashing must be pulled and replaced.
How we do it
We remove the damaged flashing sections, install new step and counter flashing that matches the roof penetration, and seal the junction so wind-driven rain stays outside.
Chimney Liner Installation
Signs you need it
Flue tile cracks visible during a camera inspection, smoke leaching into walls, or an old unlined masonry chimney that fails a level 2 inspection.
What it costs in Irwindale
Chimney liner installation in Irwindale typically runs $2,900 to $5,800 for full relining, including the liner, insulation, and termination cap.
How we do it
We inspect the flue with a camera, specify either a HeatShield resurfacing or a DuraFlex flexible liner based on the flue condition, then install the system and verify the draft.
What Chimney Repair Costs in Irwindale
| Item | Typical range in Irwindale |
|---|---|
| Chimney cap replacement | $190 – $390 |
| Chimney flashing repair | $350 – $690 |
| Chimney crown repair | $455 – $780 |
Do I always need a new liner after a chimney fire?
No. If the flue tiles are intact but the surface is cracked, we can often resurface the liner with HeatShield instead of pulling the old tile. If the tiles are broken or shifting, full relining with a DuraFlex system is the safe option. We only recommend replacement when there is camera evidence the flue cannot be saved.
Can quarry dust actually break a chimney?
The dust itself does not break anything. The problem is that it fills the chimney cap screen and traps moisture against the crown, and when mixed with creosote it hides flue cracks you need to see. Once we brush that glaze loose, a camera inspection shows what is actually underneath. Call (877) 516-7159 to get eyes on your flue.
Brands We Service in Irwindale
We stock and install professional chimney parts from Famco, Copperfield, DuraFlex, and HeatShield. These are contractor-grade materials, not hardware-store substitutes, and we keep common Irwindale sizes on the truck so repairs can happen same-visit. See our brands for the full parts lineup.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Company in Irwindale, CA
| Service | Typical range in Irwindale |
|---|---|
| Chimney cap installation | $190 – $390 |
| Chimney cap replacement | $190 – $390 |
| Chimney crown repair | $455 – $780 |
| Chimney flashing repair | $350 – $690 |
| Chimney liner installation | $2,900 – $5,800 |
| Standard chimney sweep | $169 – $259 |
| Dryer vent cleaning | $89 – $199 |
In Irwindale, the two things that push a chimney repair quote up are quarry-dust glaze that must be hand-scraped before the real work begins, and flue tile damage that only shows up after a camera inspection. We price the job before we start and you get the full quote in writing, so there are no surprise line items when the work is done.
Neighborhoods We Serve in Irwindale
We work throughout Irwindale, including the older residential streets around Arrow Highway and the single-family blocks near the 605. Because we schedule by area on specific days, response time is usually within a few days, not weeks.
- Arrow Highway corridor
- Rivergrade residential area
- Foothill Boulevard blocks
- Irwindale Avenue district
- Rivergrade and surrounding streets
Service Area – Cities Near Irwindale
Along with Irwindale, our team covers the neighboring San Gabriel Valley cities with the same specialized chimney and dryer vent work. If you’re in Covina, CA, Azusa, CA, Citrus, CA, or West Covina, CA, we schedule those routes weekly and can usually reach you within a few days.
Serving Irwindale, CA — Our Local Coverage Area
We’re based in the Irwindale area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs About Chimney Company in Irwindale
Most Irwindale chimneys should be swept once a year if you burn more than twice a week in fall and winter. If you burn only occasionally, every other year can be enough, but we recommend an inspection after any stretch of high wind because quarry dust loads the cap screen quickly. When the screen is clogged, smoke backs up into the house faster than you expect.
Routine chimney sweeping, cap replacement, and crown repair do not require a permit in Irwindale. Full liner installation or structural masonry work can require a city permit depending on scope. If a permit is needed, we tell you before the work is scheduled and you are never locked into a job that surprises you later.
Can you actually see what is wrong without guessing?
Yes. We run a camera down the flue after every sweep and you see the same image we see. In Irwindale, where quarry dust can mask cracks until a brush loosens it, that camera step matters. We only recommend liner, crown, or flashing work when there is visible evidence, and you get a copy of the report. Call (877) 516-7159 for a free estimate.
What happens when you call
- 1A real person answersNo phone trees — talk to a local chimney cleaning pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you — the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Irwindale Customers Say
"Fireplace had never drawn properly since we moved in. He found the damper was only opening halfway due to a bent linkage and fixed it in ten minutes."
— Robert Quinn"Swept it, capped it, and installed a proper damper. The downdraft smell in the summer that we'd lived with for years is gone."
— Gabriela Rodriguez"Good work. The written inspection report took about a week to arrive after I asked for it, which was slower than I expected."
— Veronica Morales